Buy Stabila 37924 - 24-Inch Electronic TECH LevelStabila 37924 - 24-Inch Electronic TECH Level Product Description:
- 24-inch TECH level that combines a Stabila spirit level and a dual display electronic level
- Vial accuracy guaranteed for life; digital displays are located on the top edge and the front face for easier and faster reads
- Permanently calibrated, epoxy locked vials
- Electronic module reads in degrees, percentage or inches-per-foot so you can set slope and pitch
- Weighs 2.2 pounds shipped; requires 2 AAA batteries (included)
Product Description
The Stabila 37924 is a 24-Inch Type 196E Electronic Level. The Stabila 37924 Level has 360° Digital Measuring to measure at any angle. The Display always reads upright no matter which angle it measured. With the Electronic Level, the user can select from °, slope or audio alert. The Top read position has an accuracy level of 1/32 over 72-Patented. Features: 360° Digital Measuring to measure at any angle. Reads upright no matter which angle it measured. Top read position has an accuracy level of 1/32 over 72-Patented. What's In The Box: Stabila 37924 24-Inch Type 196E Electronic Level Carrying Case
Customer Reviews
Most helpful customer reviews
9 of 9 people found the following review helpful.
Super!
By RH
I wanted an electronic level and when wandering through Home Depot a few weeks ago, bought a Husky 24" electronic/digital level (about $60). What a disaster. It wasn't repeatable and the display takes too long to get to a reading. For instance, putting it on a perfectly level surface, the readout will read 0.2 degrees, then after about 8 seconds, 0.1 degree, then after about another 8 seconds, 0.0 degree...or sometime it will stay at 0.1 degree. Meanwhile, the bubble vial is exactly in the middle - showing level. Putting it on a 0.1 degree slope (easily visible on the bubble level) gives readings of either 0.1 degree or 0.0 degree, and again with the same 8 second or so lag. And, there is NO calibration function, so it it's off, there's nothing that can be done about it.Then I tried an M-D Products 24" digital level (about $120). When I tested it in the level position (it did respond much quicker than the Husky), the bubble showed level and the digital readout showed 0.0 - great! But in the plumb position, when the bubble showed level, the digital readout showed something other than 0.0. BUT, it has a calibration function, so I thought I'd just calibrate it and I'd be good to go. Well, calibration needs to be done in 4 steps for the level position AND 4 steps for the plumb position, totaling 8 steps of roughly 10 seconds each and I never did get the level & plumb readings to match the bubble and read 0.0 - both at the same time.When I unpacked the Stabila (about $185) and put it on a level surface, the bubble showed level and the DUAL display (really cool feature) showed 0.0. When I checked it for plumb, the bubble showed plumb and the digital readouts showed 0.0! And, it's highly repeatable. Also, calibration is one step for level and plumb - put it on a level surface and adjust until the bubble shows exactly level. Press the CAL button twice and hold for 4 seconds - done; both level & plumb!The MODE button/feature is great allowing for setting a slope in either degrees, percentage of slope, millimeters/meter, or inches/foot. The REF button/function allows setting any angle to read 0.0 so angles can be transferred or the same angle can be used in a number of places (the M-D level doesn't have this feature). The HOLD button allows you to capture a reading when you can't easily see the display. The SOUND function starts beeping slowly at 2 degrees from level or plumb and gets faster and faster as you approach level or plumb. The tone becomes solid at level or plumb. Great feature - the M-D only beeps exactly at level or plumb. And the removable end caps have rubber protrusions that allow the level to be held against a wall without slipping - which for me is a big plus.Don't sell short the dual display. While the other levels have a slanted display so it can theoretically be read from the side or from above, the result is that reading from above is not that easily done - try using it to check the slope of a floor, for instance.And finally, it comes with a padded case!
3 of 3 people found the following review helpful.
Excellent product from Germany
By Open Mind
Straight forward features with simple operation. But every feature you want or expect including overhead, upside down display read-out. Workmanship and quality in the upper percentile. Still new but appears to be rugged and reliable. The 24" version is a perfect fit; not too long for fitting in confined spaces and can be used with longer, conventional levels (cheaper) to take care of long walls, floors, etc.
2 of 2 people found the following review helpful.
Awesome tool!
By Darrell B. AIA
I purchased the 16" version of Stabila's smart electronic level and cannot say a bad thing about it. I had a MD 24" unit before purchasing this one and it beats it hands down. The display is visible from working over top of the unit as well as from the side.I do a lot of traveling for my work and going through airport security with a 24" unit was tough, the 16" unit makes it all the easier.You can't beat this level-period.
See all 5 customer reviews...Latest Price:
See on Amazon.com!
More Info:
See on Amazon.com!
See Customers Review:
See on Amazon.com!
Buy Stabila 36448 - 48-Inch Mason Level with dead-blow shield
Cutrine plus
